Description: This is a basic easy to build electronics kit that blinks bright orange LEDs. Built around laser cut and etched acrylic this Jack-O-Lantern really catches light!
What would look cooler on your halloween costume than this D.I.Y. Jack-O-Lantern?
Sized at about 3" Wide, by 3" Tall, and is edge-lit by dual 5mm flashing orange LEDs.
Comes as a kit that is very easy to solder, CR2032 battery included.
Attach to the laser cut pumpkin, and you're set.
The PCB is a simple RC circuit. Two 5mm orange LEDs flash in an alternating pattern. Helps understand some electronics fundamentals, and a lot of fun to solder.
Includes
- Custom Acrylic etching, ships with protective tape still attached to prevent scratches
- Printed Circuit Board
- CR2032 Battery & Battery holder
- 2x 100k, 2x 1k Ohm resistors
- 2x 10uf capacitors
- 2x 2n2222 transistors
- 2x 5mm orange LEDs
- Solid wire to affix the acrylic to the PCB
Documents:
FG100HD