Blinky Jacko The Jack-O-Lantern


  • Model: jacko
  • Shipping Weight: 0.33Kg
  • 15 Units in Stock
  • Manufactured by: SpikenzieLabs

Description: This is a basic easy to build electronics kit that blinks bright orange LEDs. Built around laser cut and etched acrylic this Jack-O-Lantern really catches light!

What would look cooler on your halloween costume than this D.I.Y. Jack-O-Lantern?

Sized at about 3" Wide, by 5" Tall, this tree is edge-lit by dual 5mm flashing orange LEDs.
Comes as a kit that is very easy to solder, CR2032 battery included.
Attach to the laser cut pumpkin, and you're set.

The PCB is a simple RC circuit. Two 5mm orange LEDs flash in an alternating pattern. Helps understand some electronics fundamentals, and a lot of fun to solder.

-Custom Acrylic etching, ships with protective tape still attached to prevent scratches.
-Printed Circuit Board
-CR2032 Battery & Battery holder.
-2x 100k, 2x 1k Ohm resistors.
-2x 10uf capacitors.
-2x 2n2222 transistors.
-2x 5mm orange LEDs.
-Solid wire to affix the acrylic to the PCB.



Add to Cart:

wabusiness template