Sparkfun
Product Image | Item Name- | Price |
---|---|---|
SparkFun LiPower ShieldDescription: Is there anything an Arduino can’t do? Well, for one, most of them can’t be powered directly from a 3.7V LiPo battery; much less... |
$29.95 $20.97 Save: 30% off |
|
SparkFun Load Cell Amplifier - HX711Description: The SparkFun Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight.... |
$10.95 |
|
SparkFun Load Sensor CombinatorDescription: The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard 4-wire wheatstone configuration . If... |
$1.95 |
|
SparkFun Load Sensor CombinatorDescription: The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge... |
$2.95 |
|
SparkFun Logic Level Converter - Bi-DirectionalDescription: If you’ve ever tried to connect a 3.3V device to a 5V system, you know what a challenge it can be. The SparkFun bi-directional logic... |
$3.50 |
|
SparkFun MEMS Microphone Breakout - INMP401 (ADMP401)Description: This tiny breakout board features the ADMP401 MEMs microphone. One of the key advantages to this breakout and microphone is the bottom... |
$10.95 |
|
SparkFun micro:bit BreakoutDescription: The SparkFun micro:bit Breakout is a board that connects to the BBC micro:bit and expands the capabilities of the development platform... |
$5.50 |
|
SparkFun microB USB BreakoutDescription: This simple board breaks out a micro-B USB connector’s VCC, GND, ID, D- and D+ pins to a 0.1" pitch header. If you want to add the... |
$3.25 |
|
SparkFun MIDI ShieldDescription: The SparkFun MIDI Shield board gives your Arduino-based device access to the antiquated, but still widely used and well supported MIDI... |
$23.50 |
|
SparkFun Mono Audio Amp Breakout TPA2005D1Description: This tiny audio amplifier is based on the Texas Instruments TPA2005D1. Its efficient class-D operation means low heat and long battery... |
$8.50 |
|
SparkFun MOSFET Power Control KitDescription: This is the SparkFun MOSFET Power Control Kit, a breakout PTH soldering kit for for the RFP30N06LE N-Channel MOSFET. This kit is... |
$5.95 |
|
SparkFun MP3 Player ShieldDescription: Upgrade The SparkFun MP3 Player Shield is an awesome MP3 decoder with the capabilities of storing music files onto a run-of-the-mill... |
$28.95 |
|
SparkFun Multiplexer Breakout - 8 Channel (74HC4051)Description: The SparkFun Multiplexer Breakout provides access to all pins and features of the 74HC4051, an 8-channel analog... |
$2.95 |
|
SparkFun OpenLogDescription: The SparkFun OpenLog is an open source data logger that works over a simple serial connection and supports microSD cards up to 32GB. The... |
$16.95 |
|
SparkFun OpenPIRDescription: The SparkFun OpenPIR is a highly customizable Passive Infrared (PIR) sensor based around the NCS36000 PIR controller. Passive infrared... |
$17.50 |
|
SparkFun Paper Circuits KitDescription: Welcome to the world of paper circuits - creating electronic projects directly on paper using simple components! The SparkFun Paper... |
$17.50 |
|
SparkFun Photo Interrupter Breakout Board - GP1A57HRJ00FDescription A simple breakout PCB for the GP1A57HR photo interrupter (also known as a photogate, photodiode, or phototransistor). This PCB has three... |
$1.75 |
|
SparkFun Photon ProtoShieldDescription: You can’t have any development board without some sort of prototyping area, the SparkFun Photon ProtoShield takes care of this. This... |
$2.50 |
|
SparkFun PicoBoardDescription: The PicoBoard allows you to create interactions with various sensors. Using the Scratch programming language, you can easily create... |
$44.05 Sale: $22.03 Save: 50% off |
|
SparkFun Proto PedalDescription: The SparkFun Proto Pedal is an easy-to-assemble kit that makes building guitar effect pedals easier. Let's face it, most guitar pedals... |
$19.95 |
|
SparkFun ProtoShield KitDescription: The SparkFun ProtoShield Kit lets you customize your own Arduino shield using whatever circuit you can come up with and then test it to... |
$12.50 |
|
SparkFun Proximity Sensor Breakout - 20cm, VCNL4040 (Qwiic)Description: The SparkFun Proximity Sensor Breakout is a simple IR presence and ambient light sensor utilizing the VCNL4040. This type of sensor is... |
$7.75 |
|
SparkFun Qwiic AdapterDescription: The SparkFun Qwiic Adapter provides the perfect means to make any old I2C board into a Qwiic-enabled board. This adapter breaks out the... |
$2.95 |
|
SparkFun Qwiic Button - Red LEDDescription: Buttons are an easy and tactile way to interface with your project, but why would you want to deal with debouncing, polling, and wiring... |
$4.95 |
|
SparkFun Qwiic Cable KitDescription: The SparkFun Qwiic Connect System is constantly growing in popularity with makers. So to make it even easier to get started, included in... |
$9.95 |
|
SparkFun Qwiic EEPROM Breakout - 512KbitDescription: The SparkFun Qwiic EEPROM Breakout is a simple and cost effective option to add some extra storage space to any project. With 512... |
$5.50 |
|
SparkFun Qwiic HAT for Raspberry PiDescription: The SparkFun Qwiic HAT for Raspberry Pi is the quickest and easiest way to enter into SparkFun’s Qwiic ecosystem while still using... |
$6.95 |
|
SparkFun Qwiic Keypad - 12 ButtonDescription: Keypads are very handy input devices, but who wants to tie up seven GPIO pins, wire up a handful of pull-up resistors, and write... |
$11.50 |
|
SparkFun Qwiic Motor DriverDescription: The SparkFun Qwiic Motor Driver takes all the great features of the Serial Controlled Motor Driver (SCMD) and miniaturizes them,... |
$19.50 |
|
SparkFun Qwiic MultiPortDescription: Qwiic is a very efficient way to quickly prototype an idea but not all Qwiic-enabled devices have two ports. The SparkFun Qwiic... |
$2.75 |
|
SparkFun Qwiic Mux Breakout - 8 Channel (TCA9548A)Description: Do you have too many sensors with the same I2C address? Put them on the SparkFun Qwiic Mux Breakout to get them all talking on the same... |
$12.95 |
|
SparkFun Qwiic Pro Micro - USB-C (ATmega32U4)Description: Over at at SparkFun, they refuse to leave 'good enough' alone. That's why they're adding to the line-up of Arduino-compatible... |
$21.50 |
|
SparkFun Qwiic Shield for ArduinoDescription: The SparkFun Qwiic Shield is an easy-to-assemble board that provides a simple way to incorporate the Qwiic Connect System with your... |
$8.95 |
|
SparkFun Qwiic Single RelayDescription: Have you ever wanted to control something powerful or have you ever needed to turn on/off a high power device from your Arduino or... |
$13.95 |
|
SparkFun Qwiic Ultrasonic Distance Sensor - HC-SR04Description: You may be familiar with the classic HC-SR04 distance sensor, it is great for providing non-contact distance readings from 2cm to... |
$17.95 |
|
SparkFun QwiicBus - EndPointDescription: The SparkFun QwiicBus EndPoint is the fastest and easiest way to extend the range of your I2C communication bus. The breakout uses... |
$11.95 |
|
SparkFun QwiicBus - MidPointDescription: The SparkFun QwiicBus MidPoint works in tandem with the QwiicBus Endpoint so you can extend the range of your I2C bus and easily tap... |
$22.50 |
|
SparkFun QwiicBus KitDescription: The SparkFun QwiicBus Kit comes with everything you need to get started with the SparkFun QwiicBus system in one handy package. The kit... |
$42.95 |
|
SparkFun RedBoard - Programmed with ArduinoDescription SparkFun uses many Arduinos and they're always looking for the simplest, most stable one. Each board is a bit different and no one board... |
$21.50 |
|
SparkFun RedBot Sensor - Line FollowerDescription: The Line Follower sensor is an add-on for your RedBot that gives your robot the ability to detect lines or nearby objects. The sensor... |
$3.50 |
|
SparkFun RedBot Sensor - Mechanical BumperDescription: These simple switches are the Mechanical Bumper sensor for the SparkFun RedBot, giving you the ability to detect a collision before it... |
$6.50 |
|
SparkFun RedStickDescription: In 2015 Sparkfun developed the BadgerStick as a fun and interactive way for people to learn about soldering and engage with SparkFun... |
$24.95 $19.96 Save: 20% off |
|
SparkFun RFID Reader BreakoutDescription: This is a simple breakout board for our RFID readers. The SparkFun RFID Reader Breakout converts the 2mm pins to bread board friendly... |
$1.95 |
|
SparkFun RFID Starter KitDescription: This it the SparkFun RFID Starter Kit, an all-in-one kit that offer everything you need to get your next RFID project off the ground.... |
$51.95 |
|
SparkFun RGB and Gesture Sensor - APDS-9960Description: This is the SparkFun RGB and Gesture Sensor, a small breakout board with a built in APDS-9960 sensor that offers ambient light and color... |
$16.50 |
|
SparkFun RGB Light Sensor - ISL29125Description: If you’ve had ideas for a project that depends on the ability to sense different spectrums of visible light and react based on those... |
$7.95 |
|
SparkFun Rotary Switch BreakoutDescription: This is the SparkFun Rotary Switch Breakout, a very simple board designed to easily provide you access to each pin on our 10-position... |
$1.95 |
|
SparkFun Rotary Switch Potentiometer BreakoutDescription: The SparkFun Rotary Switch Potentiometer Breakout is a small board the allows you to add resistors to a 10-position rotary switch,... |
$2.25 |
|
SparkFun RS232 Shifter - SMDDescription: The smallest and easiest to use serial conversion circuit on the market! This board has one purpose in life - to convert RS232 to TTL... |
$17.50 |
|
SparkFun Sensor KitDescription: Do you have a good understanding of various sensors or need a variety of them for a project? The SparkFun Sensor Kit includes a sensor... |
$142.50 |